My Layered Red Velvet w/ Cheese Cake center

Makes a rich 9″ cake

Cheesecake
20 oz full fat cream cheese, at room temperature
2/3 cup white sugar
1/4 tsp salt
2 large eggs, at room temperature
1/2 cup sour cream, at room temperature
1 tablespoon all purpose flour

I started the cheesecake the day before. Preheat the oven to 325 degrees 

Grease a 9″ springform pan

In the bowl of a mixer, beat the cream cheese on medium until fluffy. Add the sugar and beat until smooth, add salt. Add eggs one at a time, making sure they are combined but not overmixing. Add the sour cream. Stir in flour and gently mix just until combined.

Cut wax paper the size of the springform pan, lay it in the bottom. Pour the batter into the greased pan over the wax paper. Bake until the cheesecake is just set in the middle, about 60 minutes. Run a knife around the sides and let the cheesecake and cool completely. Press plastic wrap onto the surface of the cheesecake and refrigerate overnight.

Red Velvet
2 1/2 cups cake flour
1 1/2 cups white sugar
1 tsp baking soda
2 tbsp cocoa powder (add more if you want it to taste more chocolaty)
1 tsp salt
2 eggs, room temperature
1 1/2 cups vegetable oil
1 pint buttermilk, room temperature
1 tsp vanilla extract
1 tsp white distilled vinegar
Red food coloring, as desired

I made the cake the day after I made the cheesecake, so it had rested overnight in the fridge and was sturdy enough to flip.

For the red velvet, preheat the oven to 350 degrees F. Grease and flour two 9″ pans.

Stir flour, sugar, baking soda, cocoa powder, and salt together in a medium bowl. In a separate bowl, beat the eggs, oil, buttermilk, vanilla extract, and vinegar until well combined. Add the dry ingredients and as much food coloring as you like. Beat until well combined, about two minutes.

Divide the batter between the two pans. Bake 25-30 minutes, rotating the pans halfway, or until a toothpick comes out clean. Cool the cakes in the pans for five minutes, then run a knife around the edges. Invert them onto cooling racks and cool completely. (I like to make the frosting at this point, while the cakes cool down.)

Cream Cheese Frosting
12 oz cream cheese, at room temperature
6 tbsp butter, at room temperature
1 tsp vanilla extract
1/4 tsp almond extract
3 cups 

Beat the cream cheese and butter in an electric mixer until very smooth and lump-free. Beat in the vanilla and almond extracts. Then stir in the powdered sugar a cup at a time until very smooth.

Assembling the cake.

Use a cake leveler or serrated knife to level the tops of the red velvet cakes. Put one of the layers, cut-side up and parchment paper removed, on a serving plate. Spread with a very small amount of frosting, just enough to cover the cake in a thin layer.

Take the cheesecake out of the fridge. Open up the springform pan and peel off the plastic wrap. The cake should be pretty sturdy. My cheesecake was still attached to the bottom of the springform pan. I simply used one hand to hold it, and gently flipped it over onto the red velvet. I lifted off the bottom of the springform pan and peeled off the wax paper. Piece of cake.

My cheesecake was wider than the red velvet. I just gently sawed a knife around the edges and trimmed the excess.

Spread another very thin layer of frosting on the top of the cheesecake. Flip the remaining layer of red velvet, cut side down, on top. Peel off the parchment paper.

Use about a third of the cream cheese frosting to cover the whole cake with a crumb coat. Basically, you want to frost the cake with as little frosting as possible, picking up all the red crumbs and sealing the cake. Refrigerate the cake for half an hour, or until the crumb coat is hardened.

Then frost the cake with the rest of the cream cheese frosting. I decorated mine with sprinkles.

Keep the cake in the fridge. It can stand at room temperature about half an hour before serving, if necessary.

Here is where you can find the original recipe, I adapted the recipe to how I would prefer it to be!